Lag Stud Cable Tensioners Set, Left Hand and Right Hand for 1/8″ and 3/16″ Cable – T316.
This set of cable tensioners is a perfect option for wooden posts/structures. for an extremely clean and uniform appearance in a single run, you can use a RH stud on one end and the LH stud on the opposite. By using two different threads you're able to roll the cable as you tighten pulling the lags into the post without twisting the cable. If you were to use the same direction thread, the cable would start twisting and would loosen over time. After you insert the wire into a tensioner, you’ll need a special cable swaging tool to crimp the two together. Be sure to double-check your cable lengths before crimping, once the swaging is completed it can not be undone.
These cable tensioners we made out of T316 stainless steel. They can be used for indoor and outdoor applications. Another great thing about this set is it won’t rust if you do install them outside. The best wire rope we’ve found to use with these cable tensioners is 1/8″ stainless cable that has a 1×19 configuration. Other options can be rough to the touch but the 1×19 is easy on the hands. We also believe it is the best looking, especially when you see it up close.
Come and order your Swage Stainless Steel Lag Screws for 3/16'' Cable
Haifan Rigging supply a range of cable railing accessories.They come with a variety of fittings for each end to suit your particular application.
To put in your order,just fill out our short enquiry form here,but please do ask us if you need anything custom-made.
If you wish to ask a question or need further advice,you are welcome to contact us.we'll be happy to help.
We are always available for clarification and for order.
We look forward to hearing from you!
